+ 49 341 492603-0 (Mon-Fri 8.00am – 4.30pm CET) | info@reflecto.de
English Customer Support
Bespoke Solutions
Fast Order Processing
 

Magnetic Container Marking

Large containers in public spaces need to be marked according to DIN 67520 and DIN 6171. Our magnetic version of the Orafol® ORALITE® 5951 container marking kit allows easy and fast application and removal.

Large containers in public spaces need to be marked according to DIN 67520 and DIN 6171. Our magnetic version of the Orafol ® ORALITE ® 5951 container marking kit allows easy and fast... read more »
Close window
Magnetic Container Marking

Large containers in public spaces need to be marked according to DIN 67520 and DIN 6171. Our magnetic version of the Orafol® ORALITE® 5951 container marking kit allows easy and fast application and removal.

No results were found for the filter!
R58570
Orafol ORALITE Magnetic Container Marking Set 5951
• Content: 8 panels (4 left-hand and 4 right-hand) • Size: 141 mm x 705 mm • Design: magnetic for temporary use • Reflectivity class: RA2/C Temporary Container Markings Our set of reflective container markings consists of 8 marking...
Content 1 Set
From €44.90 *

Ready to ship today,
Delivery time appr. 1-3 workdays

Our Product Tip: Orafol® ORALITE® Container Markings 5951

The container marking kit made of Orafol® ORALITE® 5951 reflective film consists of 8 pre-cut microprismatic film sheets (4 left-hand, 4 right-hand) with a reflectivity class corresponding to RA2/C. The red and white chevron markings have a standard size of 145 x 709 mm. The set includes the markings for one container and is available as self-adhesive for permanent application or magnetic version for temporary application.

How are Container Markings Applied Correctly?

Inside of built-up areas, containers not exceeding a size of 2.5 m in width and 8 m in length have to marked accordingly. Each side of the container has to be marked with two vertically applied reflective sheets. The markings should not be applied lower than 40 cm or higher than 1.55 m. If vertical positioning of the sheets is not possible, the markings might be applied horizontally.

Before applying container markings, please make sure the substrate is clean.

Clean the magnetic container markings with lukewarm water and common detergent only. Avoid any abrasive or aggressive cleaning agents as well as brushes with hard bristles since they can damage the film surface.

For more information, please refer to the detailed application and care instructions in the respective information sheet of each product.

Viewed